Standard Scientific Instrument - Water Bath Rectangular (Double Wall)

Water Bath Rectangular (Double Wall)

Water Bath Rectangular (Double Wall)

We are one of the leading manufacturers and exporters of the Water Bath (Rectangular), which is built in two variables, single and double walled. In case of double walled, the inner chamber is made of stainless steel and the outer wall is made of either stainless steel or mild steel duly coated.

Construction

All Baths are single/double walled in construction. In case of double walled Baths, the outer wall is made of Mild Steel Sheet and the Inner wall is made of suitably thick Stainless Steel Sheet of 304 quality. The Baths are painted in an attractive stove enamel spray paint. (SS exteriors are also provided as per requirements.)

Other accessories

• 75 mm holes on top with concentric rings
• Workable on 220 Volt 50Hz. A.C
• Digital temperature controller ± 1°C
• P.I.D controller ± 0.5°C.
• Temperature range up to 99°C.
• Thermostatically Controlled Accuracy ± 5°C

Heating & Cooling

Heating is provided through long lasting sealed heaters supported on refractory bases / immersion type heater fixed at the bottom of the working chambers. A hermetically sealed compressor, coupled with an evaporation coil and fan cooled condenser, assembled in an easily serviceable tray at the bottom provides the cooling for below ambient temperatures.

Temperatures

The temperature ranges from above ambient to 100° C in all heated baths but extends to 250° C in case of Oil Baths. In the Low Temperature Baths, the temperature ranges from ambient to - 40° C. Accuracy is as per table attached.

Safety

Water level arrangement is provided in most of the Baths to

Source:-http://www.laboratorytestingequipment.in/water-bath-rectangular.html