Ductility
Ductility
Spares:
Mould-3 Nos. Made of brass/gunmetal mounted on a base
plate. Each mould has two end clips, two sides with knurled screws and
side support for proper assembly on the base plate. One spare mould with
base plate for casting the specimen is also supplied.
Water Bath Thermostatically Controlled :
A bath maintained with ± 0.1 °C of the specified test temperature,
containing not less than 10lt. of water, the specimen being immersed to a
depth of not less than 100 mm and supported on a perforated shelf not
less than 50 mm from the bottom of the bath.
Testing Machine : The machine has
two rate of travel, namely 5 cms per minute and 1 cm per minute. A
clutch arrangement is provided by which the movement of the movable
bracket can be arrested or restarted without switching off the motor. A
scale on the top edge of the bath makes it easy for the operator to
opserve the progress of the test. Machine accommodate three individual
specimens. A quick release mechanism permits the operator to move the
carriage to any desired position on the track. An automatic cut off
prevents over runs. Immersion heater also provided.
A three wire cord with plug is furnished with the bath.
The control panel is recessed. Controls consists of a
temperature, an on-offline switch which controls all power to the bath,
and pilot light which indicates when the heater are energized.
Operation on 230 volts, single phase, 50 cycles, A.C. supply.
Spares:
Ductility Mould with base plate made of gunmetal.
No comments:
Post a Comment
Note: only a member of this blog may post a comment.